Equipotential Bonding; Instructions For Use; Safety Instructions - Weller WS 80 Betriebsanleitung

Setting the temperature
The digital display (2) shows the actual value temperature. By pressing the UP or DOWN
key (3, 4) the digital display (2) switches to the setpoint. The setpoint can be changed
by tapping or by firmly pressing the UP or DOWN button (3, 4) in the desired direction.
Pressing the button will change the setpoint quickly. The digital display (2) returns
automatically to the actual value approximately 2 seconds after releasing the button.
Maintenance
The transition between the heating element / sensor and the tip of the soldering iron
may not come in contact with dirt, foreign particles or become damaged, since this
affects the precision of the temperature control.

3. Equipotential bonding

The various circuit elements of the 3,5 mm jack bush make 4 variations possible:
Hard-grounded: No plug (delivery form)
Equipotential bonding: With plug, equalizer at center contact (impedance 0 ohms)
Potential free: With plug
Soft-grounded: With plug and soldered resistance. Grounding with set
resistance value.

4. Instructions for use

For initial heating, coat the selective tinnable tip with solder. This removes any oxidation
or dirt on the tip which may have occurred during storage. During pauses between
soldering and before storing the soldering iron, ensure that the tip of the soldering iron
is well coated. Do not use aggressive fluxing agents.
Note: Always ensure the proper position of the soldering iron tip.
These soldering irons have been adjusted for an average-size tip. Deviations can occur
due to exchanging of the tip or using other tip designs.
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

5. Safety instructions

The manufacturer assumes no liability for uses other than those described in the
operating instructions, or for unauthorized alterations.
These operating instructions and warnings should be read carefully and kept in an
easily visible location in the vicinity of the soldering iron. Non-observance of these
warnings can result in accidents, injury or risks to health.
The WELLER soldering stations WS 80 and WS 50 are in compliance with the EC
Declaration of Conformity in accordance with the basic safety requirements specified
by Directives 89/336/EEC and 73/23/EEC.
23