Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Do not cover the steam openings during operation. Allow
the steam to escape unhampered.
CauTIOn:
•
Do not place the steamer under wall cabinets!
•
The steamer and accessories are not suitable for use
in stoves (microwave, convection or conventional) or on
stovetops!
Instant steam function
The special steam pipe will
release steam after a few
seconds. This component
covers the heating element
and regulates the subsequent
water flow.
Put the steam pipe over the
heating element with the small
notch facing down.
Filling with water
nOTE:
Fill the water reservoir with clear and clean water only. Do not
put any other liquids or add any salt, pepper, etc. in the water
reservoir.
•
The water level indicator shows the water level in the water
reservoir.
•
Fill the reservoir till the maximum level (1.6 liter).
•
When steaming longer than 15 min., always fill the reser-
voir till the maximum level.
Condensation collection tray
Place the collection tray in the base unit.
using one steam bowl
1. Place steam bowl on top of the collection tray.
2. Place vegetables, fish or other foods without sauce or
liquids into the steam bowl. Do not completely cover the
steam openings!
3. Cover the upper bowl with the lid.
using two or three steam bowls
1. Place a steam bowl on top of the drip tray.
2. Place the biggest piece of food with the longest cooking
time into the lower steam bowl.
3. Place one connecting frame on top of it.
4. Place the second steam bowl on top of the connecting
frame.
5. Place the desired food into the bowl.
6. If you want to use a third steam bowl, install a connecting
frame again between the steam bowls.
7. Cover the upper bowl with the lid.
38
using the rice bowl
1. Put rice or other foods with sauce or liquid in the rice bowl.
2. Place the rice bowl into a steam bowl.
3. Finally, put the lid on.
nOTE:
Please continue observing our "Cooking instructions". There
you will find suggestions on water quantities for different rice
grades.
Mains connection
1. Check if the mains voltage that you want to use matches
that of the appliance. You will find the information about this
on the type plate of the basic unit.
2. Make sure the timer is switched off.
3. Connect the device to a properly installed isolated ground
receptacle.
Initial operation
•
After filling with water, first place the collection tray and then
the steam bowls and the lid.
•
Position the lid with the steam opening on the back.
Switching on
Use the timer switch to set the desired cooking time. The
control lamp indicates the operating mode.
Terminating operation
Turn the timer switch anti-clockwise till the end. Disconnect the
mains plug from the mains.
adding more water
Water can be added during operation using the opening on the
right side of the base unit. This does not require you removing
the steam bowls.
•
When the water level reduces during operation, use a suit-
able vessel to slowly add water through this opening.
•
Check the water indicator level while doing so.
Stop operation
When the time has expired, the heating process will stop
automatically. The control lamp turns off.
1. Disconnect the plug from the mains.
WarnInG:
•
Always use pot holders or oven mitts when handling or
removing hot components in order not to get burned by
hot steam!
•
The liquid in the collection tray is hot!
2. Remove the steam bowls first and the collection tray last.
Werbung
Inhaltsverzeichnis
