ATIKA ALH 2500 Bedienungsanleitung Seite 15

Mains fuse
2200 W 16 A time-lag
2300 W 16 A time-lag
2400 W 16 A time-lag
2500 W 16 A time-lag
On / Off switch
Do not use any device where the switch can not be switched
on and off. Damaged switches must be repaired or replaced
immediately by the customer service.
ON
Infeed
Direction of rotation
selector switch
Switch on
Press the green button I .
Switch off
Press the red button 0 .
Restart protection in case of power
failure
In case of a power failure, the device switches off automatically
(zero-voltage initiator). To restart, press the green button again.
Motor protection
The motor is equipped with a safety switch and switches off
automatically when overloaded. After a cooling-down break
(approx. 5 min), the motor may be restarted. Press the
1. reset button (motor protection)
2. green button I to restart.
14
Switzerland UK
10 A time-lag 13 A time-lag
10 A time-lag 13 A time-lag
13 A time-lag
13 A time-lag
Reset button
(motor protec-
tion)
OFF
Reverse
Direction of rotation selector switch
Only actuate the direction of rotation selector switch
while the shredder is switched off.
Position
The material is drawn in by the cutting roller and shredded.
Position
The blades operate in the opposite direction and jammed material
is released.
Keep depressing the green button of the on/off switch once you
have placed the direction of rotation selector switch into the
position. The cutting roller is placed into the opposite direction. If
you release the on/off switch, the shredder automatically stops.
Hints
Large objects or pieces of wood may be removed after the
shredder has been operated several times both in cutting
and in release direction.
Use a tamper or hook to remove jammed objects from the
hopper or ejection slot.
Always wait until the shredder has come to a complete
standstill before restarting it.
Electrical mains supply impedance
When conditions in the electrical mains supply are un-favourable,
voltage reductions for short periods can occur during the process
of turning on the equipment, which can adversely affect other
equipment (e.g., the flickering of a lamp).
No breakdowns are to be expected if the maximum, electrical
mains supply impedances given in the table are met.
Power consumption P (W)
1
2200
2300
2400
2500
W o r k i n g w i t h t h e
W o r k i n g w i t h t h e
Choose a working position alongside the equipment or be-
hind it. Never stand near the ejection opening.
Longer material that is protruding from the device could
spring back when it is drawn in by the blades! Observe safety
distance!
Never reach into the filling or ejection opening.
Keep your face and body away from the filling opening.
Never place hands, other parts of the body or clothing into the
filler funnel, ejection channel or in the vicinity of other moving
parts.
Check that no chopped residues are in the filling hopper be-
fore switching on the equipment.
Electrical mains supply
impedance Z (Ω)
max
0,21
0,21
0,21
0,21
g a r d e n s h r e d d e r
g a r d e n s h r e d d e r