Heat Level - Heating Period - therm-ic SmartPack rc 1600 Gebrauchsanweisung

 Every time you push the "-" control button
(Fig. 3.2), the heat level drops.
 The respective heat level is indicated by the
flashing of the heat setting display on the
SmartPacks and the remote control (Fig. 1.2 and
3.1)
switched off
  
low heat level
  
moderate heat level
  
high heat level
  
Turning off the heat (standby):
 Press the "-" control button of the remote control
(Fig. 3.2) for a longer period of time (3 seconds)
to turn off the heat.
 The SmartPacks are now in standby mode.
 The heat setting display on the SmartPacks (Fig.
1.2) briefly flashes at an interval of 2.5 seconds.
 Press the "+" or "-" control button again to turn on
the heat again.
STANDBY
  
Note:
If you are using the remote control, both
SmartPacks will be set to the same heat level.
H E A T LE V E L - H E A T I N G P E R I O D
For your orientation, the following table shows the
max. temperature and the heating period for the
heat levels, which can be set using the control
buttons.
– 29 –