Power Off; Use And Function - therm-ic SmartPack rc 1600 Gebrauchsanweisung

SmartPack rc (with remote control)
The SmartPacks rc have three operating modes:
POWER OFF – STANDBY – IN USE. These
modes are clearly indicated on the SmartPack heat
setting and remote control display. The number of
illuminated LEDs corresponds to the selected heat
setting.

POWER OFF:

 The SmartPack is completely turned off and the
heat setting display (Fig. 1.2) is permanently off.
 They can only be turned on by using the + / -
control button (Fig. 1.3) of the SmartPacks.
Note:
If the SmartPack is not used for 24 hours, it
automatically switches into POWER-OFF mode.
IN USE:
 The SmartPack is supplying the connected
Therm-ic insole with power.
switched off
  
low heat level
  
moderate heat level
  
high heat level
  
STANDBY:
 The SmartPack is in idle position and can be
activated with the control button of the remote
control (Fig. 3.2) or with the +/- control buttons of
the SmartPacks (Fig. 1.3).
 The heat setting display (Fig. 1.2) briefly flashes
at an interval of 2.5 seconds.
STANDBY
  
U S E A N D FU N C TI O N
Operating the SmartPack
– 27 –