Automatic Mode; General - Vestamatic Rolltec Plus G/S 500 Montage- Und Bedienungsanleitung

Automatic mode

Push the selector switch to (A), all the way to the left until you hear
the "click", in order to activate the automatic mode.
The automatic mode is now activated and the roller shutter will move
up and down at the programmed times. Regardless of the pro-
grammed times, it is still possible to move the roller shutter up and
down by pressing the up or down button and the programming
remains unaffected.
If you press the up or down button longer than 2 seconds, the roller
shutter moves up or down.
Simply press the opposite button to stop the motion, i.e.:
press the down button, if the roller shutter is moving up,
press the up button, if the roller shutter is moving down.
The roller shutter will only move up or down again after the up or
down button has been pressed.
By simply pushing the selector switch to manual mode (H), the auto-
matic mode can be interrupted for an extended period of time.
After selecting automatic mode again, the control will execute the last
pending command from the automatic mode. The last pending com-
mand will also be executed when resetting after power failure.
Introduction
- 45 -
Basic functions
After the installation has been completed correctly (for instructions
please see pages 67 to 74), you can start programming.
IMPORTANT!
x
Please note that the control cannot be programmed in case
of power failure.
Carefully pull to remove the cover cap and press the reset button with
the delivered adjustment tool or something else suitable.
Pressing the reset button will activate the default times pre-programmed
by the manufacturer.
Current time –
Up time –
Down time –
On the following pages, you will find instructions how to customize
these times to your personal requirements.
G G
0ß8:0ß0
0ß6:0ß0
2ß0:0ß0
- 46 -

General