Vestamatic Rolltec Plus G/S 500 Montage- Und Bedienungsanleitung Seite 21

Rolltec Plus G/S 500
Roller Shutter Control
Installation and Operating Instructions
Safety precautions
– Contact a professional electrician to install the control
Ä
as well as for setting of the DIP switches on the rear
panel of the device, because the power supply requires
a power supply of 230VAC, 50 Hz.
– Check the control system for signs of mechanical
damage after unpacking. If you notice any shipping
damage, do not start up the control system and notify
your supplier immediately.
– The control system should only be used for the purpose
specified by the manufacturer (refer to the operating
instructions). Any changes or modifications thereof are
not permissible and will result in loss of all warranty
claims.
– If the control unit cannot be operated without presenting
a hazard, it must be switched off and prevented from
being switched on unintentionally.
– When performing work on the windows, controls or con-
nected shades, protect them against unauthorised or
unintentional operation.
G
- 40 -