Concord WANDERER Handbuch Seite 41

• The cover material colour may run slightly
when wet, in particular during washing.
• Do not use solvents on the cover!
After washing the cover, guide the straps from the harness bucklet through
the matching plastic eyelets and check to ensure the harness is working
properly and safely! Then replace the back plate in the closable bag on the
rear of the cover and press the Velcro fastener together.
To replace the cover, thread the cover into the Keder rail, starting with the
head area and finishing with the footrest area. Close the press studs and
then use the Velcro fasteners to connect the cover parts together.
As one final check, make sure that the cover is correctly anchored in the
Keder rail, and that all fasteners and connectors are securely closed.
All of the cover parts, tube frame parts and plastic components on the
CONCORD WANDERER can be wiped down with a damp cloth.
manual_WANDERER_130109-WEST-final.indd 39
Replace the straps from the tilt
adjustment system and thread
these as shown through the plastic
eyelet. Check to ensure that all
straps are correctly positioned and
secured.
39
09.01.13 23:27