Backlight Mode; Backlight Level - Audiotec Fischer DIRECTOR Benutzerhandbuch

5.1.2 Backlight Mode

This menu is used to configure the backlight of the display individually. There are four options available:
• Auto (High): The backlight is automatically dimmed if a high level is detected at the illumination wire (8 - 18 V)
• Auto (Low): The backlight is automatically dimmed if a low level is detected at the illumination wire (GND / Ground)
• Dim: The backlight is dimmed permanently (set to the backlight dim level)
• On: The backlight is permanently set to full brightness
In addition a display timeout value can be adjusted between 0 and 60 seconds by using the control dial. The timeout is
triggered if no user interactions are recognized for the adjusted time frame. In this case the display brightness is set to
the backlight timeout level.
Note: The dim- and timeout brightness of the display can be individually adjusted in the Backlight Level menu.

5.1.3 Backlight Level

This menu is used to change the dim and timeout brightness by using the control dial. If the timeout brightness is set to
"0" the display is completely turned off after the time is expired.
Note: The configuration of the dim and timeout function has to be adjusted in the Backlight Mode.
41