Bluetooth ® Control Menu; Tone Control Menu; Voltage Monitor - Audiotec Fischer DIRECTOR Benutzerhandbuch

4.5 Bluetooth Control menu
®
As soon as a connection to the Bluetooth device is established, the Bluetooth Control menu can be used. It allows to
® ®
send play/pause, skip forward and skip backward "commands" to your Bluetooth device. In addition the control dial can
®
be used to control the HEC/MEC BT volume. The adjusted volume is displayed below the buttons.
Note: The Bluetooth menus are only displayed if a HEC/MEC BT module is installed in the device.
®

4.6 Tone Control menu

This menu allows to control the level and the crossover frequency of the bass and treble by using the control dial. The
control range of the bass level and its crossover frequency is from -6 dB to +6 dB and from 10 Hz to 1.000 Hz. The
increments are graded in 0.25 dB / 10 Hz steps. The control range of the treble level is as well from -6 dB to +6 dB, its
crossover frequency from 1.000 Hz to 20,000 Hz. The increments of the treble are graded in 0.25 dB / 100 Hz steps.
Note: The control dial always adjusts the red lighted function. Press the control dial in order to toggle between bass and
treble control. By tapping on the respective bar you can toggle between the gain and frequency indicator panels.
Note: In order to enable the DIRECTOR Tone Control, the feature has to be activated at first in the Device Configuration
Menu (DCM) of the DSP PC-Tool software. Through the activation of the Tone Control the 2nd band of each channel
will be deactivated.
Caution: Pay attention that adding Tone Control boosts can overdrive the system.

4.7 Voltage Monitor

37