Audiotec Fischer DIRECTOR Benutzerhandbuch Seite 34

3. Initial operation
The following shows the important steps for the activation process:
1. Connect the DIRECTOR with the provided USB cable to the USB port of your computer. Do not prolong the included
USB cable with a passive extension cable; otherwise a proper communication can not be ensured. To extend the
included cable always use an active USB cable with an integrated repeater.
2. Switch on the DSP / amplifier with DSP and start the DSP PC-Tool software. The DIRECTOR will be turned on au-
tomatically.
Note: If the operating software of the DSP is not up-to-date it will be updated automatically.
3. Go to the Device Configuration Menu in the DSP PC-Tool software. In the Extended Features tab you can activate
the DIRECTOR as a remote control.
4. To finish the setup and save the adjustment click on the Save & Store button.
5. The activation is finished.
34