Input Select Menu; Bluetooth ® Connect Menu - Audiotec Fischer DIRECTOR Benutzerhandbuch

4. Explanation of the main functions

4.3 Input Select menu

The Input Select menu is used to select the different input sources of the connected device. Depending on the connect-
ed device the following sources are available: Main, HEC/MEC/AUX and Digital optical. In addition the control dial can
be used to control the volume of the active source. The adjustment range is from - 60 dB to 0 dB and is displayed below
the buttons. The increments are graded in 0.5 dB steps.
Note: The manual switching between input sources by the DIRECTOR needs a specific configuration in the DSP P C-Tool.
Each source signal detection in the DCM menu has to be set to "Manually via Remote Control".
4.4 Bluetooth Connect menu
®
The DIRECTOR allows the direct control of the HEC/MEC BT extension module. The Bluetooth Connect menu con-
®
tains the following functions to control the connection:
• Connect: The Bluetooth module tries to establish a connection to the last connected device
®
• Pair: Activates the Bluetooth pairing mode
®
• Disconnect: Disconnects the actual Bluetooth connection
®
• Volume control: The control dial can be used to control the volume of the connected source in 0.5 dB steps.
The assigned Bluetooth module name is displayed below the buttons. The name can be changed in the DSP PC-Tool.
®
36