Wolf BML-EXCELLENT Bedienungs-, Wartungs- Und Montageanleitung Seite 24

The control unit BML Excellent should be placed at
a height of approximately 1.65 meters above the
The control unit BML Excellent may not be covered,
for example, by a curtain or a cabinet;
Consult paragraph
requirements.
Settings, which have not been described
approved by Wolf GmbH. Do not change these by
yourself.
Careful! Clean the screen with a soft cloth.
Careful! Never apply water and/or (cleaning) liquid to
the screen.
The control unit BML Excellent may not
be removed as unsorted urban waste, but should be
treated separately.
Make enquiries within your own region,
where the control unit BML Excellent can be handed
in when use has been terminated. Do not throw away
electrical appliances or parts, but check if (parts of)
the control unit BML Excellent cannot be handed in,
recycled or re-used.
Assembly and installation should be performed by an installer
approved by Wolf GmbH.
through paragraph 3.1.4, one by one, to assemble the Control
unit BML Excellent.
Disconnect the operational module from the wall bracket.
Perform the following actions
ing at the bottom of the operational module (see
Slowly tilt the screwdriver downwards. The operational
module clicks loose and can be removed (see
The following actions should be performed to connect the
Control unit BML Excellent electrically (see
Feed the two-core wire (from the appliance to be con-
nected) through via opening at the back of the wall
bracket.
correct manner. If this is not the case, do so.
24
1.2 for environmental
:
A)
B)
):
Screw the cable to the terminal No. 1 and No. 2. Consult
the installation instructions of the appliance to be con-
nected, for more information on the correct connection.
The wall bracket can be attached to a wall box (Ø 55 mm) or
can be directly mounted on the wall with screws and plugs.
Screw the wall bracket onto the wall in the correct posi-
tion. Here one must use the mounting holes in the wall
bracket (see )
Consult paragraph 2.2 for more informa-
tion on placing the control unit BML Excellent.
Place the operational in the wall bracket mounted on the wall.
Perform the following actions for this (see
Shift the pins at the top of the operational module to the
openings intended for them in the wall bracket.
Turn the bottom of operational module towards the wall
bracket
The operational module should click onto
the wall bracket. Only then is a proper electrical con-
nection established.
Perform the following actions to set the language (see
Press return 2 as many times as necessary to get to the
Main menu
Press 1
Press
1
Select a language by turning
Press to set the selected language
1
The names of the described menu items
items if the control unit BML Excellent is set to a lan-
guage other than English.
The control unit BML Excellent only has 24 hour representa-
- tion. Perform the following actions to set the time (see
Press return 2 as many times as necessary to get to the
Main menu
Press
1
Press
1
Press
1
Change the time by turning
Press
1
Repeat the previous two steps for both the minutes and
seconds
):
1
1
1
1
1
1
Art.-Nr.: 30 63 420
):
):