Dynamic Anti-Scalding Protection - STIEBEL ELTRON FFB 4 EU Bedienung Und Installation

oPERATIoN
Appliance description
Function of memory keys "1" and "2"
When either of the memory keys are pressed, the temperature
saved for them is briefly displayed. If no other key is pressed within
the next second, the temperature displayed is directly transmitted.
Function keys "+" and "-"
When the keys "+" or "-" are pressed, the most recently transmitted
temperature is briefly displayed. If no other key is pressed within
the next second, the temperature displayed is directly transmitted.
You can change this temperature in 0.5 °C steps by pressing any
other key.
Holding down "+" or "-" changes the temperature display in 0.5 °C
steps until the key is released again.
When the key is released, the required temperature is transmitted.
The required temperature is transmitted approx. 0.5 seconds after
the last key is pressed. The progress bar on the display indicates
that data is being transmitted.
f To shut down the heating system, set a temperature of 20 °C. f
Then press "-" again.
16 | FFB 4 EU
Saving temperature to memory keys
f Set the required temperature using the keys on the wireless f
remote control.
f Press memory key "1" or "2" for 2 seconds. The temperature f
display flashes once to confirm. You can set the memory keys
individually for each wireless remote control / programming
unit.
Note
When activating the anti-scalding protection in the in-
stantaneous water heater, you can only set the DHW tem-
perature to between 20 °C and 43 °C. Higher temperature
settings are not implemented.
3.2

Dynamic anti-scalding protection

With dynamic anti-scalding protection, once the user selects a
temperature at the appliance programming unit or the wireless
remote control, they then automatically have priority for setting
the maximum temperature. This priority is available for 2 min-
utes or until 2 minutes after the end of the current draw-off.
After this, the priority is automatically disabled.
Whilst the priority is enabled, the temperature can be reduced
or increased to a maximum of 43 °C by other programming
units.
www.stiebel-eltron.com