Cleaning And Care - Gastros InductCook 330 Betriebsanleitung

Cleaning and Care

Glass ceramic
We recommend using pots and pans with completely flat bases to avoid any potential surface damage such as scratches.
If you use a cold cooking surface as a work surface, remember to wipe it down afterwards. Remaining crumbs or
grains underneath cookware may cause scratches. However, scratches will not impair the cooking process in any way.
Cleaning tips:
• First, use a scraper to remove all large pieces of dirt and food leftovers from the cooking surface.
• Then squeeze a few drops of a suitable cleaning product on to the cold surface and rub it in with kitchen paper or
a clean cloth.
• Then wipe down the cooking surface with water and rub it dry with a clean cloth.
• Clean your cooking surface regularly, preferably after each use.
Important: If any plastic objects, aluminium foil, sugar or food containing sugar accidentally melt on to the
hot cooking surface, wipe them off the hot cooking zone immediately with a cleaning scraper to prevent
surface damage. Never use scouring sponges or scouring products. Chemically aggressive cleaners such as
oven spray and stain remover are also unsuitable.
Daily Cleaning
For cleaning: Switch off the InductCook
temperature before starting to clean.
Please note: Do not use steel wool or sharp objects. Your induction cooking appliance is not splash-water resistant.
Therefore, do not use running water or steam to clean it. To remove dirt and deposits on side walls, you can use
standard pH-neutral cleaning products based on non-ionic and anionic tensides and mild organic solvents such as
alcohol and glycols. Finally, remove all cleaning product residue, wipe down the cleaned surfaces with water, and rub
dry with a dry cloth.
Weekly Cleaning
In addition to daily cleaning, the air filter (5) must be cleaned once a week. Firstly to ensure a sufficient supply of
cooling air and secondly to prevent the filters' effectiveness for grease and other vapours from being impaired.
To do this remove the filter (5) from below the air inlet. Clean the filter in a dishwasher or with hot water and soap.
Refit the filter correctly before using your InductCook
Important: A dirty filter may cause overheating, resulting in a drop in performance and damage to the
InductCook 330 appliance! A missing filter may allow dirt to accumulate, resulting in a drop in performance
®
and damage to the InductCook
330 appliance. Wait until the InductCook
®
330 appliance again.
®
330 appliance!
®
330 appliance has cooled to hand
®
17