Dietz 66040 Bedienungsanleitung Seite 29

To exit the procedure, you must press and keep pressed one of the memorized buttons till the LED light
YELLOW. As soon as you release the button the LED will blink GREEN.
It's necessary infact to select the radio protocol needed (see radio tables).
Radio profile setting
It's necessary now to select the radio protocol needed (see radio tables).
On default the unit offers the first profile available that is the CLARION, the GREEN LED make's one flash.
With the attached table select the radio needed so verify how many flashes it must to do the LED related to the
radio of interest.
If the radio we want to set it's the first one just press SEEK + to confirm the selection, the LED will light on
GREEN.
To select a different radio press VOLUME + on the steering wheel to increase the number of flashings of the
LED or VOLUME - to decrease.
Once the radio desired is selected to confirm the choice press SEEK + on the steering wheel. the LED will light
on GREEN as confirmation.
The logic of the flashes of the LED follows this behaviour:
LED GREEN flash meaning= units
LED RED flash meaning= tens
For example 5 GREEN flashes of LED, indicate the radio in the 5th position.
2 RED flashes of the LED, indicate the radio in position 20.
1 RED flash of the LED followed by 2 GREEN flashes of the LED indicate the radio in position 12.
Once the radio of interest is selected to confirm the choice press SEEK + on the steering wheel.
The led of the unit will light GREEN.
COMMENTS:
Unit is ready to work when LED light GREEN, now if you press any button recognized the LED light will be
YELLOW.
In case of anomaly, do the procedure of RESET
To RESET the unit, press and keep pressed the button till the LED flashes RED.
®
Copyright © by Audiotechnik Dietz Vertriebs-GmbH ● Germany
Stand: 04 / 2016
29
English