Nolan N87 Sicherheit Und Gebrauchsanleitung Seite 20

15.6 Insert the upper flap "B" of the frame into the loop on the back of the cheek pad
and reattached the eyelet "A" at the top press stud on the back (Fig. 16).
15.7 Remove the left cheek pad from the helmet (see instructions above).
15.8 Repeat the same process with the right cheek padding.
16. Removing space for the eyewear
16.1 Remove the left cheek pad from the helmet (see instructions above).
16.2 Unhook the eyelet "A" on the rear frame of the corresponding cheek pad at the
upper press stud on the back (Fig. 16).
16.3 Remove the upper flap "B" of the frame from the loop on the back of the frame
itself (Fig. 16).
16.4 Correctly insert part of the previously-removed padding inside the cheek pad
fabric lining cover (Fig. 17).
16.5 Insert the upper flap "B" of the frame into the loop on the back of the cheek pad
and reattached the eyelet "A" at the top press stud on the back (Fig. 16).
16.6 Reattach the complete cheek pad in the helmet (see instructions above).
16.7 Repeat the same process with the right cheek padding.
VENTILATION SYSTEM
The ventilation system of the N87 helmet consists of:
Chin guard air intake:
For the maximum effectiveness of the ventilation, adjust the air intake as per Figure
18A, with the air intake completely open or Fig. 18B, with air intake completely closed.
Front air intakes (left and right):
nels the air coming from the front air intake by directing it in the top area of the rider's
head without any dispersion. See Fig. 19 for opening and closing.
Rear extractor: is integrated into a rear spoiler and allows the removal of warm and
stale air, ensuring maximum comfort inside the helmet (Fig. 20).
N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
Your Nolan helmet is factory-preset to be equipped with the N-Com communication
system. During the communication system installation (see the specific instructions
contained in the N-Com kit), it will be necessary to remove the foam material fillers
located in the polystyrene cheek pads next to the N-Com earphones seats.
A series of supports are also provided as an accessory which MUST be used to fas-
ten the various N-Com keypads to the helmet's shell. Please contact an authorized
Nolan Dealer.
WARNING
- The above-mentioned fillers should only be removed if the helmet is used with an
N-Com compatible system installed.
allows ventilation in the mouth and visor area.
the innovative AIRBOOSTER TECHNOLOGY chan-
20