Inhaltsverzeichnis
Werbung
8. Lead the air sand blaster to the workpiece and press the
trigger (6) to start the delivery of air and to start-up the sand
blaster. The more you press the trigger, the stronger the sand
blast will be. If necessary, perform some test runs on an unused
workpiece before work.
9. Release the trigger to stop the delivery of air and to stop sand
blasting.
10. Turn the regulator clockwise to close it.
11. After use, disconnect the tool from the compressed air
generator.
12. Then clean the air sand blaster with a moist cloth.
Air Pressure and Air Volume
Operate the air sand blaster with a pressure of 6 bar using a
compressor with an air suction capacity of at least 200 l/min.
When using higher pressure for operating the air tool than the
max. permitted pressure of 8 bar, its self life will be reduced
drastically. The ideal capacity is provided by compressors with a
suction capacity of 300 – 400 l/min.
Only use air hoses with an inner diameter of at least 9 mm. When
setting up the air pressure, always keep in mind that the pressure
will decrease by approx. 0.6 bar when using a 10 m long hose
with an inner diameter of 9 mm.
Operation
10
Werbung
Inhaltsverzeichnis
