General Safety; Safety Instructions; Electrical Connection - fors WA 8447 Benutzerhandbuch

General Safety

Do not change the specification of this appliance.
•
Obey the maximum load volume of 8 kg (refer to the
•
"Programme chart" chapter).
The operating water pressure (minimum and maximum)
•
must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).
The ventilation openings in the base (if applicable) must not
•
be obstructed by a carpet.
The appliance is to be connected to the water mains using
•
the new supplied hose-sets. Old hose sets must not be
reused.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Before maintenance, deactivate the appliance and
•
disconnect the mains plug from the mains socket.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.

SAFETY INSTRUCTIONS

Installation
• Remove all the packaging and the transit
bolts.
• Keep the transit bolts. When you move
the appliance again you must block the
drum.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Do not install or use a damaged
appliance.
• Obey the installation instruction supplied
with the appliance.
• Do not install or use the appliance where
the temperature is less than 0 °C or
where it is exposed to the weather.
• Make sure that the floor where you
install the appliance is flat, stable, heat
resistant and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• Adjust the feet to have the necessary
space between the appliance and the
carpet.
• Do not install the appliance where the
appliance door can not be fully opened.

Electrical connection

• The appliance must be earthed.
• Always use a correctly installed
shockproof socket.
• Make sure that the electrical information
on the rating plate agrees with the
power supply. If not, contact an
electrician.
• Do not use multi-plug adapters and
extension cables.
3