Inhaltsverzeichnis
Werbung
AT A GLANCE
_______________________________________________________________
1
2
3
4
5
11
12
13
14
15
16
Splitter array A
Splitter array B
17
18
10
9
8
GAF 5859
6
7
STC 1880
220-240V~ 50/60Hz
Made in Germany
27
26
25
MULTI
MODE
M
24
23
GRUEN
BR141
+5V
+5V
BR142
22
+5V
BR143
+5V
+12V
BR144
+12V
BR139
BR145
21
+25V
ROT
BR105
+18V
+18V
OFF
max 500mA
BR146
+33V
19
20
AT A GLANCE ___________________________________________
The fully equipped head station at a glance
Housing cover
SAT-INPUT
A, SAT input socket A
8 level controls for the RF output signal (lines 1 to 8)
OUTPUT, RF output socket (to house aerial system)
SAT-INPUT
B, SAT input socket B
~
Mains socket (220 - 240 V
, 50/60 Hz)
Type plate
Ø
Earth terminal (for 2.5 mm
or 3.5 mm
3 fixing screws for housing cover
Ventilation holes of housing cover
Fixing screws for modulator mounting brackets
Modulator mounting brackets
8 fitted modulators
Connector for decoder retrofit kit
Analog or digital unit
8 SAT tuners
Passive input splitter with 2 splitter arrays (A and B) in one housing
Active output collector
Mains fuse, below protective cover
of the mains unit
Protective cover of mains unit
Mains and control unit
RS 232
connector, 9-pin serial interface
Sockets
B1
and
B 2
for the power supply of the analog and digital modules
Socket
for the power supply of the extension module
B 3
Keys of the control unit
Display contrast control
Two-line display
I
Metal clamp, earth connection (
–
) from the mains and control unit to the
chassis frame.
with plug: + 5 V– supply voltage for the active output collector.
Green lead
Red lead
with plug: +12/18V– supply voltage, max. 500mA , for the LNB
power supply via the SAT inputs
SAT-INPUT A
Note:
The LNB supply voltage which must be selected (0V or +12V– or
+18V–) depends on the connected LNB.
The procedure is described on page 14 in the chapter "Adjusting the
LNB supply voltage".
Ø
earth cable)
and
SAT-INPUT
B.
Werbung
Inhaltsverzeichnis
