Possible Applications; Disassembling The Appliance - AEG Electrolux M8000 Gebrauchsanweisung

822 949 413_M8000_AEG.book Seite 12 Mittwoch, 5. November 2008 3:34 15
g
Child Safety
• Do not leave the appliance running
while unattended, or let children near
the appliance unsupervised!
• Children should be supervised to
ensure that they do not play with the
appliance.
• Packaging material, e.g. plastic bags,
should not be accessible to children.
When operating the appliance
• Always place the unit on a flat, level
surface.
• Never operate the appliance with wet
hands.
• Ensure the Speed Selector is in the off
position before plugging into the
power outlet.
• Plastic parts should never be dried at
or near direct sources of heat.
• The appliance must not be used for
mixing dyes (paints, or lacquer, etc,).
This can cause explosions!
• When you have finished using the
appliance, before cleaning, switch off
and pull the plug out of the socket.
• The blade assembly should only be dis-
assembled by an authorised technician.
• Never clean the motor casing under
running water or soapy water.
• Caution! The blade assembly is very
sharp. Be careful when taking the
blender apart and re-assembling. It
may cause injury if handled incor-
rectly.
• Do not leave hard objects (for example
spoons) in the blade assembly while
running, and do not grasp the appli-
ance with the hand inside the blender
tank. This may cause injury!

Possible applications

The blender can be used for mixing a
wide variety of drinks, crushing ice, re-
ducing fruit and vegetables, whipping
cream, etc.
12
Cord storage
The appliance is fitted with a cord stor-
age facility at the bottom. If the con-
nection cord to the power outlet is too
long, it can be wraped around the cord
storage until it is the required length.

Disassembling the Appliance

0 Take the plug out of the socket.
0 Remove the lid (Fig. 1/B).
0 Remove the blender tank (Fig. 1/C).
0 Turn the blender blender tank upside
down.
0 Turn the blade assembly counterclock-
wise using the filler cup (Fig. 1/A) as
tool and remove (Fig. 3). The grooves of
the filler cup fit the ribs of the blade
assembly.
0 You can now remove the rubber seal
(Fig. 4).
1 Caution! The blade assembly is very
sharp. It can cause injury if handled
incorrectly! The rubber seal can easily
be irreparably damaged by the blade
assembly.
Caution! Do not use force when taking
the blade assembly out of the blender,
as this might cause damage. If neces-
sary, tilt it slightly when removing.
Do not attempt to remove the stainless
steel blades from the blade assembly.
Assembling the Blender
0 Place the rubber seal on the blade
assembly.
0 Insert the blade assembly into the
blender tank from the bottom. Turn it
clockwise to fasten it (Fig. 5). Caution!
Handle carefully!
3 You can use the filler cup as tool.
The blender tank will leak if the blade
assembly is not assembled correctly.
0 Seat the tank on the motor housing.
0 Set the lid on the blender tank.
0 Insert the filler cup, and lock it in.