Installing The Ventilation System - Dometic RMS 8400 Installationsanweisung

The ventilation grilles must have an open
cross-section of at least 250cm². This is
achieved by using the Dometic L100 / L 200
Correct mounting of the lower ventilation grille facilitates access to the connecti-
ons and functional parts during maintenance.
6.4

Installing the ventilation system

The L100 upper vent system kit consists of the
mounting frame (R1640), the air grille including
flue gas duct (A1620) and the winter cover
(WA120). The L200 lower vent system kit con-
sists of the mounting frame (R1650), the air gril-
Fig. E16
Fig. E17
Fig. E18
Fig. E14
1.
Seal the mounting frame
making it waterproof
(does not apply for
mounting frames with
integral seal) .
2.
Insert frame and screw
into position.
3.
Insert ventilation grille.
THE SIGN OF COMFORT
absorber ventilation and air extraction system
which has been tested and approved for this
purpose.
le (A1630, but without flue gas duct) and the
winter cover (WA130). To install the ventilation
grilles, cut two rectangles (451 mm x 156 mm)
in the outer wall of the vehicle (for position of the
cuts, see point 6.3).
Fig. E19
Fig. E20
9
Fig. E15
4.
Lock ventilation grille.
5.
Clip the insert for flue
gas duct in position (only
for L100 upper ventilati-
on system kit).
6.
Insert winter cover.
Fig. E21