Temperature Display; Prior To Initial Start-Up; Starting Up And Temperature Regulation - AEG Electrolux SK 98843-6I Gebrauchsanleitung

DESIRED temperature means:
The temperature that is required in the refrigerator, this can be adjusted to
the temperatures shown in the display. The DESIRED temperature is indicated
by flashing numbers.
ACTUAL temperature means:
The temperature display indicates the temperature that is currently present
in the refrigerator. The ACTUAL temperature is indicated by continuously
illuminated numbers.

Temperature Display

The temperature display can indicate several pieces of information.
During normal operation, the temperature currently present in the
refrigerator (ACTUAL temperature) is displayed.
When the temperature is being adjusted, the temperature currently set
flashes (DESIRED temperature).

Prior to Initial Start-Up

Please clean the appliance interior and all accessories prior to initial startup
(see section: "Cleaning and Care").

Starting up and temperature regulation

1. Insert the plug into the plug socket. When the refrigerator compartment
door is opened, the internal lighting is switched on.
2. Press ON/OFF button. The green mains pilot indicator illuminates.
3. Press either the "+" (WARMER) or "-" (COLDER) button. The temperature
display switches over and the DESIRED temperature currently set flashes on
the temperature display.
4. Set the required temperature by pressing the "+" (WARMER) or "-" (COLDER)
buttons (see section "Temperature setting buttons"). The temperature display
will immediately show the changed setting. With each further press of one of
the two buttons, the DESIRED temperature is adjusted by 1°C. Adjustable
temperature range: +2°C to +8°C.
Note: From a food safety point of view, +5°C for the refrigerator
compartment should be considered cold enough as a storage temperature.
5. Once the required temperature has been set, after a short period (approx. 5
sec.) the temperature display will change and again indicate the current
ACTUAL temperature inside the fridge.
The display will change from flashing to continuous illumination. The
compressor will start and then run automatically.
49