Use and Control
Before Use
Wait two hours before connecting the appliance to allow the oil to flow back
in the compressor.
Before using the appliance for the first time, wash the interior and all internal
accessories with lukewarm water and some neutral soap so as to remove the
typical smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these will damage the finish.
Remove safety elements used for transportation.
Control panel
A Pilot light (green)
B ON/OFF switch
C Temperature setting buttons (for
warmer temperatures)
D Temperature display
E Temperature setting buttons (for colder temperatures)
F SUPERCOOL indicator light (yellow)
SUPERCOOL for intensive fridge cooling
G Push button for SUPERCOOL
Temperature Setting Buttons
The temperature is adjusted using the "+" (WARMER) and "-" (COLDER)
buttons.
These buttons are connected to the temperature display.
The temperature display is switched over from the display of the ACTUAL
temperature (temperature display is illuminated) to the display of the
DESIRED temperature (temperature display flashes) by pressing one of the
two buttons, "+" or "-".
With each further press of one of the two buttons, the DESIRED temperature
is adjusted by 1°C.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL
temperature.
48