Herunterladen Diese Seite drucken
Hess SERA Gebrauchsanleitung
Vorschau ausblenden Andere Handbücher für SERA:

Werbung

Gebrauchsanleitung
Installation and Operating Instructions
Notice de montage et d´installation
Manual de instrucciones
Istruzioni d'uso
LED
S E R A 600
S E R A 600 G
S E R A 600 S
2018/04/A
1

Werbung

loading

Inhaltszusammenfassung für Hess SERA

  • Seite 1 Gebrauchsanleitung Installation and Operating Instructions Notice de montage et d´installation Manual de instrucciones Istruzioni d’uso S E R A 600 S E R A 600 G S E R A 600 S 2018/04/A...
  • Seite 2: Indicazioni Importanti

    Hess Licht + Form non risponde in alcun modo di danni cau- sati da un impiego non corretto. Il montaggio...
  • Seite 3 PMMA Reinigung LED-Modul: Risikogruppe 2, nicht in Leuchtenabdeckungen aus PMMA-Kunststoff den Strahl blicken! dürfen nur mit Wasser und Spülmittel, bei Die Leuchte ist so zu positionieren, dass starken Verschmutzungen mit Waschbenzin längeres in die Leuchte schauen in einem gereinigt werden. Andere Mittel sind nicht geringeren Abstand als 0,4m nicht zu erwar- erlaubt, insbesondere die Verwendung ten ist.
  • Seite 4 Lieferumfang Included in Luminaire Purchase Matériel fourni Programa de entrega Volume di consegna S E R A ø mm ø mm ø mm ø mm 10.20001.4500 4500 – 76,1 – – 10.20001.6000 6000 1000 – 76,1 – – 10.19900.0 Levo –...
  • Seite 5 Lieferumfang Included in Luminaire Purchase Pièces fournies Programa de entrega Volume di consegna S E R A G ø mm ø mm 10.20001.4500 4500 – 76,1 4754 10.20001.6000 6000 1000 – 76,1 6254 10.39910.0 – – 1210 76,1 – – 10.39910.2 –...
  • Seite 6 Lieferumfang Included in Luminaire Purchase Pièces fournies Programa de entrega Volume di consegna S E R A G ø mm ø mm 10.20001.4500 4500 – 76,1 4523 10.20001.6000 6000 1000 – 76,1 6023 10.39920.0 – – 76,1 – – 10.39920.2 –...
  • Seite 7 Empfohlene Montagefolge Recommended Installation Procedure Déroulement de montage recommandé Secuencia de montaje recomendada Sequenza di montaggio consigliata S E R A S E R A S E R A G / GA S E R A S Wartung Kabelbelegung Einstellmöglichkeiten “DIM Modul“...
  • Seite 8 Ériger le mât / Monter la console Montaje del poste/ Montaje del brazo mural Montaggio del palo / Montaggio dello sbraccio • • • y • SERA 600 x = min. 1200 mm y = min. 250 mm T y p SERA 4500 10.09910.4500...
  • Seite 9 Poids / Surface de résistance au vent Pesos / Superficie expuesta al viento Pesi / Superficie di resistenza al vento ∑ Artikel-Nr. m² SERA 4500 10.09910.4500 6000 10.09910.6000 SERA G 4500 1210 mm (1x) 10.09901.4500 2420 mm (2x) 10.09903.4500 6000 1210 mm (1x) 10.09901.6000...
  • Seite 10 Montage Mounting Montage Montaje Montaggio 20 Nm 20 Nm 16 Nm 20 Nm 16 Nm...
  • Seite 11 0° 5° 10° 15° 12 Nm...
  • Seite 12 Kabelübergangskasten Junction Box Boîtier de raccordement Caja de empalmes Cassetta di distribuzione per i cavi ACHTUNG: Die mit X markierte Anschluss- belegung in der Spalte „Variante“ beachten ATTENTION: Please note the assignment of con- nections as marked with X in the column “Variante” ATTENTION: Merci de noter l´affectation des rac- cordements, marquée par „X“...
  • Seite 13 La luminaria debe cambiarse si falla antes de que finalice el periodo de vida útil esperado: véase www.hess.eu/9970 L´apparecchio non richiede praticamente nessuna manu- tenzione. E´comunque previsto che il modulo Led e lo stabiliz- zatore elettrico, anch´esso modulare, possano essere sostituiti anche singolarmente.
  • Seite 14 Wartung LEVO Maintenance LEVO Entretien LEVO Mantenimiento LEVO Manutenzione LEVO 4 LEVO...
  • Seite 15 5 LEVO ancien nouveau viejo nuevo vecchio nuovo 4.6A...
  • Seite 16 Wartung LEVO Maintenance LEVO Entretien LEVO Mantenimiento LEVO Manutenzione LEVO 6 LEVO...
  • Seite 17 7 LEVO Wärmeleitpads müssen am Gehäuse anliegen! The heat conduction pads must fixed to the housing! Les pads conducteurs de chaleur doivent adhérer au boîtier! Los circuitos thermicos debe ser applicado a la carcasa misma! Le piastrine termiche devono rima- nere applicati alla cassaforma!
  • Seite 18 RAP module compliant to information on the type identification plate. ATTENTION. N´utiliser que des modules RAP conforme à la plaque d´identification. PRECAUCIÓN: Use solo módulos Sera Nr. 0.112.04.168 RAP según la placa de características. Seriennummer: T002078059 Leistung: Spannung: 230V ~50Hz...
  • Seite 19 9 RAP...
  • Seite 20 Wartung RAP Maintenance RAP Entretien RAP Mantenimiento RAP Manutenzione RAP 10 RAP...
  • Seite 21 11 RAP ancien nouveau nuevo viejo nuovo vecchio...
  • Seite 22 Wartung RAP Maintenance RAP Entretien RAP Mantenimiento RAP Manutenzione RAP 12 RAP...
  • Seite 23 13 RAP...
  • Seite 24 Kabelbelegung Wiring diagram Positionnement brins de câble Tendido de cables Assegnazione dei cavi H05SS-F 3G1² Schutzklasse I braun grün/gelb blau Protection rating I brown green/yellow blue Classe électrique I brun vert/jaune bleu Clase de protección I marrón amar./verde azul Classe di Isolamento I marrone verde/giallo H05SS-F 2X1²...
  • Seite 25 H05SS-F 4X1² Schutzklasse II Step DIM / Lineswitch blau schwarz grau braun Protection rating II Step DIM / Lineswitch blue black grey brown Classe électrique II Step DIM / Lineswitch bleu noir gris brun Clase de protección II Step DIM / Lineswitch azul negro gris...
  • Seite 26 Einstellmöglichkeiten “DIM Modul” Settings “DIM Modul” Possibilités de réglage “Module DIM” Posibilidades de ajuste “Módulo DIM” Possibilità di regolazione del “Modulo DIM” StepDIM Nachtabsenkung über Steuerleitung Absenkung auf 30% / 50% / 70% (weitere Stufen auf Anfrage) Programmierung via Software Serienmäßig integriert Dims via a control lead Dims to 30% / 50% / 70%...
  • Seite 27 Integrazione di serie HINWEIS: Änderungen und Entschlüsselung der Dimmeinstellungen siehe www.hess.eu/9980 NOTE: For information about dimmer codes and changing the dimmer settings, go to www.hess.eu/9980 REMARQUE: Modifications et décodage du réglage du système de gradation d´ éclairage: voir www.hess.eu/9980 PRECAUCIÓN: Para las modificaciones y la descodificación de los ajustes de regulación véase www.hess.eu/9980...
  • Seite 28 Hess GmbH Licht + Form Lantwattenstraße 22 D-78050 Villingen-Schwenningen Tel. +49 7721 / 920-0 Fax +49 7721 / 920-250 info@hess.eu www.hess.eu...

Diese Anleitung auch für:

Sera gSera s