Scanning 35Mm Negatives & Slides; Auto Image Mirror/Flip; Feeding Filmstrips - Pandigital PANSCN05 Bedienungsanleitung

Scanning 35mm Negatives & Slides
 This Photo Converter only supports the scanning of 35mm negative/monochrome 6-frame filmstrips and un-mounted
positive slides, commonly available from your local photo studios. Mounted films/slides are not supported.
 Filmstrips in certain conditions are not suitable for scanning. Refer to Suitable and Unsuitable Original Types on
page 5.

Auto Image Mirror/Flip

The Photo Converter can detect the orientation of a filmstrip when the printed numbers on the edge of the filmstrip
are in the same orientation as the image.
If you feed the filmstrip with the image mirrored or upside-down, the Photo Converter will automatically adjust the
scanned image during the scan.
The following orientations would result in the same scanned image:
For example, the bottom image (above) is upside-down but the numbers are right-side up. If fed in this
orientation, the image would not be rotated, resulting in the scanned image remaining upside-down.
 The current "auxiliary" OCR capability has difficulty distinguishing the direction of some numbers, (i.e.,"6", "9"). If
the number's position is near the edge of the film, it can easily be worn out or damaged, and then it can't be
detected in the expected position, or meet the required condition above causing the Auto Mirror/Flip function to be
disabled.

Feeding Filmstrips

1. Make sure that the feeding slot is clear of any original.
2. Slide the paper guide lever all the way to the right side of the feeding slot.
3. Align the negative & slide adapter with the grooves and then gently insert it all the way into the feeding slot, being
careful not to bend the metal parts.
When installed properly, the negative & slide adapter should firmly snap into place, and the Photo
Converter will begin a calibration.
Wait until indicator lights are in the "Ready to use" status before proceeding.
CAUTION: For accurate film scanning, the film adapter must remain snapped into position after the
No rotation required
Auto mirrored
Auto flipped
If the numbers and image are not in the same orientation,
the auto mirror/flip function will not rotate the image.
calibration has completed. If you move the adapter, scanning will give inaccurate results.
If necessary, remove and re-insert the film adapter properly to re-calibrate.
Final scanned image
9