Frequently Asked Questions; Limited Warranty - Pandigital PANSCN05 Bedienungsanleitung

Film feeding
Dimensions
Net weight
Operating Temperature
Operating Humidity
Storage Temperature
F r e q u e n t l y A s k e d Q u e s t i o n s
Q: There are strange lines on the scanned image, or the image is not clear.
A: Check the following:

Are there scratches on the original, or is the original clean? Remove any stains or dust from the original before scanning.

Did you insert your original into the plastic sheath before scanning?

Has the Photo Converter been used for a long period of time without cleaning and calibration? Follow the instructions for
"Cleaning the Photo Converter" on page 14 and "Calibrating the Photo Converter" on page 15, and then try again.
Q: The scanned filmstrip image is not rotating properly
The current "auxiliary" OCR capability has difficulty distinguishing the direction of some numbers, (i.e.,"6", "9"). If the number's
A:
position is near the edge of the film, it can easily be worn out or damaged, and then it can't be detected in the expected
position, or meet the required conditions causing the Auto Mirror/Flip function to be disabled (see page 9). Please follow the
indicator on the film adapter to re-scan the filmstrip.
Q: The original is stuck halfway in the feeding slot.
A: Press the Power button; the Photo Converter will eject photos out the front, and films will be ejected out the back.
Q: The status indicator blinks rapidly, no scan is possible, or the converter powers off automatically.
A: Check the following:

Is the memory card inserted properly into the memory card slot? Re-insert the card and try again.

Is the SD card locked (set to write-protect)? Unlock the card.

Is the memory card full? The indicator blinks when the free space on the memory card is below 1MB. Use another card if
necessary.

Make sure the memory cards are in FAT or FAT32 file formats only, not NTFS or any other file format. Reformat the
memory card if necessary to use it with the converter.

Did you insert the next original before the scanning process of the previous one was completed? Power the Photo
Converter off and back on and try again. Make sure that you scan the next original only after the scanning process of the
previous one has completed.

Does the length of the original exceed the maximum acceptable size? Refer to "Suitable and Unsuitable Original Types"
on page 5 for more information.
Q: The Photo Converter feels warm to the touch.
A: It is normal for the Photo Converter to emit a small amount of heat (around 30-45oC) after prolonged use. However, if there
are strange odors coming from the Photo Converter or the Photo Converter feels hot to the touch, disconnect the Photo
Converter immediately from the power supply or the PC. (Refer to safety precaution – use only included power adapter;
page 3.)
L i m i t e d W a r r a n t y
The limited warranty set forth below is given by Pandigital with respect to Pandigital brand electronics products purchased and
used in the United States of America. Pandigital warrants this product against defects in material or workmanship as follows:
LABOR: For a period of one (1) year from the date of purchase, if this product is found to be defective, Pandigital will repair or
replace the product, at its option, at no charge. After this one (1) year, labor charges will be charged on a case by case basis.
PARTS: For a period of one (1) year from the date of purchase, if this product is found to be defective, Pandigital will supply at no
cost, new or rebuilt replacement parts, at its option, at no charge. After this one (1) year period, parts will be charged for on a case
by case basis. Modifications not approved by the party responsible for compliance could void user's authority to operate the
equipment.
This warranty does not cover: (1) customer instruction, installation or setup; (2) cosmetic damage or damage due to accident,
misuse, abuse or negligence; (3) commercial use of the product; (4) modification of any part of the product; (5) damage due to
improper operation, improper maintenance, or connection to an improper power supply; (6) loss of data, regardless of value or
format, that may result through proper and/or improper use of the product; (7) damage due to an attempted repair of the product
by anyone other than a facility authorized by Pandigital to service the product; (8) consumables (such as fuses and batteries).
This warranty is valid only in the United States.
The product must be accompanied by a copy of the original retail purchase receipt. If no proof of purchase is attached, the
warranty will not be honored and repair costs will be charged. This warranty is only valid with written documentation detailing the
16
Filmstrip-fed type (negative & slide adapter required)
2-1/8" (L) x 6-1/8" (W) x 2-1/4" (H)
68 mm (L) x 158mm (W) x 41 (H) mm
0.5 lbs (224g)
o o
15ºC ~ 35ºC (59 F~95 F);
20% RH ~ 70% RH
o o
-20ºC ~ 60ºC (59 F~95 F); 10% RH ~ 90% RH