Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Insert the photo into the sheath as shown below.
2. Insert the sheath into the feeding slot of the Photo Converter flat and level.
Keeping the original flat and level when feeding prevents possible jamming.
Keep originals free from finger prints, oil, dirt, and dust for optimum scanned image quality.
Remove photos from the sheath after scanning to prevent the sheath from sticking to the photos over time.
If the plastic sheaths are not in use, store them in a safe place and keep them protected from accumulating dust.
O r i e n t a t i o n o f t h e O r i g i n a l a n d S c a n n e d I m a g e
Refer to the illustrations below for the relationship between the orientation of the original when scanning and that of the scanned
image when displayed on the computer screen.
Photo Converter
Photo Converter
Scanning the same original in different orientations may produce scanned images that look slightly different in color tones and
brightness. This is not a malfunction.
O p e r a t i n g t h e P h o t o C o n v e r t e r
Preparation and Initial Setup
1. Peel off the tape that secures the guide lever (first time only).
2. Connect the plug on the power adapter to the power connector on the Photo Converter.
3. Plug the power adapter into a power outlet.
The type of power plug and socket illustrated may differ from that of your region.
4. Insert the supplied SD memory card, or any supported unlocked (writable) memory card, into the memory card
slot.
Always insert a memory card before scanning.
Make sure the memory card is unlocked (writable)
The Photo Converter only accepts memory cards in FAT16 or FAT32 file system. NTFS and other file
systems are not supported.
Power on the Photo Converter
1. Press the
information, refer to "Indicator Lights" on page 5.)
Original
Original
Power
button. The power indicator and Status/Card lights blink. (For more indicator lights
Scanned image when
displayed on-screen
7
Werbung
Kapitel
Inhaltsverzeichnis
