Inserting / Replacing The Battery; Cleaning And Maintenance - EuroLite LED Ribbon SMD5050 Bedienungsanleitung

INSERTING / REPLACING THE BATTERY

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom of the IR remote control and remove it. If replacing the battery, remove
the old battery from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
CAUTION!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

CLEANING AND MAINTENANCE

DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
There are no serviceable parts inside the device. If defective, please dispose of the unusable LED Ribbon
SMD5050 in accordance with the current legal regulations.
Should you have further questions, please contact your dealer.
11/12 00062139.DOC Version 1.0