Set Temperature; "Antifreeze"Mode - Sonnenkönig Slim M 1000 Bedienungsanleitung

1.heating" indicator light
It is illuminated when the unit's heating is on.
2.Thermostat handle
It is used to set the desired room temperature.
3.Two-button switch, with display
It is used to select the following heating power modes: I mode (low power), II mode
(medium power), III mode (high power).
Operation of slim series convector
EN
1.Switch on the convector
Connect the convector to electric mains by plugging the power cord into an eletric outlet.
2.Select the heating power
2.1 Press button "1"to select low heating power, at that the indicator light of button
"1"will be illuminated.
2.2 Press button "2" to select the medium heating power, at that the indicator light of
button "2" will be illuminated.
2.3 Press button "1" and "2" to select the high heating power, at that indicator lights
of both buttons will be illuminated.

3.Set temperature

3.1 .Temperature can be set within the range +5 to +30°C.
3.2 Turn the thermostat handle clockwise to the stop to positon"max", at that is room
temperature is below the set one, then the"heating" indicator light must be illumi-
nated. When the room temperature reaches the desired level, turn the thermostat
handle counterclockwise until the unit is switched off, the "heating" indicator
light will go out. Now the thermostat will maintain the set temperature, switching
on and off the convector from time to time.

4. ."Antifreeze"mode

Turn the thermostat handle counterclockwise to position"min". The thermostat will au-
tomatically switch on heating of the convector, if the room temperature goes below +5℃
and the unit is connected to electric mains and the heating mode is on.
5. "Comfort" mode
"Comfort" mode, which can be selected by means of the thermostat handle, corresponds
to the most comfortable room temperature.
6. Switch off the convector
Set the buttons of the heating power mode selector to position "0"and disconnect the
unit from electric mains
52