Herunterladen Inhalt Inhalt Diese Seite drucken

Control Of The Convector - Sonnenkönig Slim M 1000 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Slim M 1000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connection to electric mains
1.The convector is designed to be connected to 230V single-phase voltage mains with a
grounding circuit.
2.Prior to connection comply parameters, indicated on the identification plate with tech-
nical data of the unit.
3.It is necessary to follow active electrical safety precautions, connecting the convector
to electric mains.
4.An electric outlet must be properly grouded. The outlet must be designed for rated
current not less than 10A. Electric outlet and plug must always stay dry to prevent current
leakage. Regularly check if the electric plug is tightly connected to the outlet. It must be
done in the following order:connect an electric plug into an outlet, after half hour ope-
ration turn off the convector and disconnect the plug from the outlet, check if the plug
is heated by your hand. If the plug heated over 50℃ then replace the outlet by a new one
to prevent damages, incidents, fire as a result of bad elteric contact. A specialist must do
the job.
IMPORTANT!
The electric outlet must be rated for not less than 10A, electric cable with a strand with
cross section not less than 3x1.5mm2(for copper)..

5 Control of the convector

The electric outlet must be rated for not less than 10A, electric cable with a strand with
cross section not less than 3x1.5mm2(for copper).
Slim M 1000 / Slim M 1500 / Slim M 2000 Control panel
(Fig. 8)
51
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis