Description Of The Convector; Installation - Sonnenkönig Slim M 1000 Bedienungsanleitung

3 Description of the convector

(Fig. 3)
1. Control panel
2. Outlet grill louver
3. Unit's case(front part)
4. Cold air inlet
5. Support leds

4 Installation

Wall mounting of the convector (Fig.4,5,6) dimensions are given in mm.
1.Open the factory package and carefully remove the unit out of it.
2.Remove seals out of foamed plastic on sides of the unit and take it out of polyethylene.
3.In accordance with Fig.2,4 and table 2,determine the place of convector's installation
observing minimun distances from objects and minimun distance from the floor.
4.Make the height, at which the convector is to be mounted, then attach bracket to the
wall.
5.Put visible marks in mounting holes.
6.Drill holes of the required diameter on the mounting holes, inset dowels, attatch the
mouting bracket and fasten adjusting screws, thereby securing bracket on the wall (Fig.5).
1
2
3
4
5
(Abb. 4)
49
EN