Washing Programmes - IKEA RENLIG DWTI60 Bedienungsanleitung

ENGLISH
Delay start button
Use the delay start button to delay the start
of the washing programme with an interval
of 3 hours. Refer to the chapter 'Setting and
starting a washing programme'.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are off and the
end indicator light flashes.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel
the programme to go back to the setting
mode. Refer to the chapter "Setting and start-
ing a washing programme".
Programme indicator lights A and B
Apart the selection of the corresponding wash-
ing programme, these lights have an auxili-
ary functions:
• The adjustment of the water softener level.
• Deactivation/activation of the audible sig-
nals.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.

Washing programmes

Washing programmes
Programme
Intensive
Degree of Type of
soil load
Crockery,
cutlery,
Heavy soil
pots and
pans
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold the programme selection/
cancel button until programme indicator
light A flashes and programme indicator
light B comes on.
4. Press the programme selection/cancel
button again.
– Programme indicator light A comes on.
– Programme indicator light B starts to
flash.
5. Wait until programme indicator light A
goes off.
– Programme indicator light B continues
to flash.
– The end indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel
button again.
– The end indicator light goes off.
The audible signals are deactivated.
7. Switch off the appliance to save the oper-
ation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end in-
dicator light comes on.
Programme description
Prewash
Main wash up to 70°C
2 intermediate rinses
Final rinse
Drying
7