Setting And Starting A Washing Programme - IKEA RENLIG DWTI60 Bedienungsanleitung

ENGLISH

Setting and starting a washing programme

Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then it is
possible to modify the settings.
Do these steps to set and start a washing pro-
gramme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press the programme selection/cancel
button again and again to set the washing
programme. Refer to the chapter 'Washing
programmes'.
– The programme indicator light comes
on.
4. Close the door.
– The washing programme starts auto-
matically.
When the washing programme operates,
you cannot change the programme. Can-
cel the washing programme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Cancelling a washing programme
1. Press and hold the programme selection/
cancel button for approximately 3 seconds.
– The programme indicator light goes off.
– The end indicator light starts to flash.
2. Release the programme selection/cancel
button to cancel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent be-
fore you set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of
interruption.
Setting and starting a washing programme
with delay start
1. Press the on/off button.
2. Set a washing programme.
– The programme indicator light comes
on.
3. Press the delay start button.
– The delay start indicator light comes on.
4. Close the door.
– The countdown of the delay start starts.
– When the countdown is completed, the
washing programme starts automatical-
ly.
Do not open the door during the count-
down to prevent interruption of the count-
down. When you close the door again, the
countdown continues from the point of inter-
ruption.
Cancelling a delay start:
1. Open the door.
2. Press the delay start button.
– The delay start indicator light goes off.
3. Close the door.
– The programme starts immediately.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signals for the end of the pro-
gramme operate.
1. Open the door.
– The end indicator light comes on.
– The programme indicator light stays on.
2. Press the on/off button.
3. For better drying results, keep the door
ajar for some minutes before you remove
the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are easily
damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
15