Electrical Connection - IKEA RENLIG DWTI60 Bedienungsanleitung

ENGLISH
Caution! Do not use connection hoses
from an old appliance.
Caution! If you connect the appliance to
new pipes or pipes that are not used for
a long time, we recommend to run the water
for some minutes before you connect the inlet
hose.
Aqualock inlet hose
The inlet hose is a high pressure resistant. It can
hold pressure at maximum 6 MPa. From ex-
ternal the inlet hose has a sheathing against
eventual damages. If the inner hose breaks,
the water that is in the hose will became dark.
You can see it across the special transparent
sheathing. Turn off the water tap immediately
and contact the After Sales Service.
A
B
The aqualock inlet
hose is installed with
a safety device to
prevent accidental
loosening. To discon-
nect the hose:
• Press the lever ( B ).
• Turn the retaining
ring ( A ) anticlock-
wise.

Electrical connection

Warning! The manufacturer is not
responsible if you do not follow these
safety precautions.
Ground the appliance according to safety pre-
cautions.
Make sure that the rated voltage and type of
power on the rating plate agree with the volt-
age and the power of the local power supply.
Turn the inlet hose to
the left or the right to
suit the installation.
Tight the locknut cor-
rectly to prevent wa-
ter leaks.
If you use a inlet
hose extension
the total reached
length must be no
longer than 4 metres.
Drain hose
Always use a correctly installed shockproof
socket.
Do not use multi-way plugs, connectors and
extension cables. There is a risk of fire.
Do not replace the mains cable yourself. Con-
tact the After Sales Service.
Make sure that the mains plug is accessible
after installation.
If you connect the
water drain hose to a
water trap under the
sink, remove
A
plastic membrane
(A). If you do not re-
move the membrane,
remaining food can
cause a blockage in
the drain hose spigot.
Caution! Make
sure that the
water couplings are
tight to prevent wa-
ter leakage.
20
the