Installation; Electrical Connection; Noises - Electrolux EUN12510 Benutzerinformation

Problem
6.1 Closing the door
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to

"Installation".

7. INSTALLATION
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the plug
accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST

8. NOISES

There are some sounds during normal
running (compressor, refrigerant circula-
tion).
Possible cause
The door is not closed
correctly.
The temperature regulator
is not set correctly.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
Solution
Refer to "Closing the door".
Set a higher temperature.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Cli- Ambient temperature
mate
class
T +16°C to + 43°C

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
Refer to the assembly instructions
for the installation.
ENGLISH 23