Electrolux EUN 12300 Gebrauchsanweisungen Seite 56

Ha
Hc
PR266
5. Separate parts Ha, Hb, Hc, Hd
figure.
ca. 50 mm
ca. 50 mm
6. Place guide on the inside part of the furniture door,
up and down as shown in the figure and mark the
position of external holes. After having drilled
holes, fix the guide with the screws supplied.
Ha
Hc
PR33
7. Fix cover (Hc) on guide (Ha) until it clips into
place.
Hb
Hd
as shown in the
90°
90°
PR167
8. Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
PR167
9. Remove the brackets and mark a distance of
8 mm from the outer edge of the door where the
nail must be fitted (K).
PR168
10. Place the small square on the guide again and fix
it with
Should the lining up of the furniture door be
necessary, use the clearance of slots. At the end
of operations, it is necessary to check if the door
of the furniture closes properly.
56
8mm
Ha
Hb
8mm
K
Ha
Hb
the screws supplied.