AEG HK683320FG Benutzerinformation Seite 15

Problem
The sensor fields become
hot.
The backlight is on, but the
contrast of the display is
bad.
There is no signal when you
touch the panel sensor
fields.
II and text come on.
comes on.
? comes on.
E and a number come on.
Possible cause
The cookware is too large or
you put it too near to the
controls.
The hot cookware is on the
display.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The cookware does not cov-
er the cross / square.
There is an error in the hob.
ENGLISH
Remedy
Put large cookware on the
rear zones if possible.
Remove the object and let
the hob become sufficiently
cool. If the contrast is not
clear, speak to an Author-
ised Service Centre.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Cover the cross / square
fully.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If E comes on again, speak
to an Authorised Service
Centre.
15