What To Do If - AEG HK654070XB Benutzerinformation

24

What to do if...

To remove the dirt:
1. – Remove immediately:melted plastic, plastic foil, and food with sugar. If not, the dirt
can cause damage to the appliance. Use a special scraper for the glass . Put the scra-
per on the glass surface at an acute angle and move the blade on the surface .
– Remove after the appliance is sufficiently cool:limescale rings , water rings, fat
stains, shiny metallic discolorations. Use a special cleaning agent for glass ceramic or
stainless steel.
2. Clean the appliance with a moist cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.
WHAT TO DO IF...
Problem
You cannot start the appliance
or operate it.
A sound operates when the ap-
pliance is off.
The residual heat indicator does
not come on.
You cannot switch on the outer
ring.
A sound operates and appli-
ance starts and stops again. Af-
ter 5 seconds one more sound
operates.
comes on
and number come on.
There is no signal when you
touch panel keys
If you tried the above solutions and cannot repair the problem, speak to your dealer or the
Customer Care Department. Give the data from the rating plate, three-digit-letter code for
Possible cause and remedy
• Start the appliance again and set the heat setting in 10 sec-
onds.
• The child safety device or
vice or . See the section "Child safety device" or "Stop and
go".
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the
control panel
You covered one or more sensor fields. Uncover the sensor fields.
Clean the control panel.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the after sales
service.
Switch on the inner ring first.
You covered . Uncover the sensor field.
The automatic switch off operates. Stop the appliance and start it
again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the after sales
service.
The signals are off.
Switch on the signals.
operates . Stop child safety de-