The Heat Setting; Switching The Outer Rings On And Off; Automatic Heat Up; Using The Timer - AEG HK654070XB Benutzerinformation

20
Operating instructions

The heat setting

Touch the control bar at the heat setting.
Change to the left or the right, if it is neces-
sary. Do not release before you have a cor-
rect heat setting. The display shows the heat
setting.
/

Switching the outer rings on and off

You can match the effective heating surface to the size of the cookware.
To switch on the outer ring touch the sensor field
more outer rings touch the same sensor field again. The next indicator comes on.
Do the procedure again to switch off the outer ring. The indicator goes out.

Automatic Heat Up

You can get a necessary heat setting in a shorter time if you activate the Automatic Heat
Up function. This function sets the highest heat setting for some time (see the graphic), and
then decreases to the necessary heat setting.
To start the Automatic Heat Up function for a cooking zone:
1. Touch
2. Immediately touch the necessary heat setting. After 3 seconds
play.
To stop the function change the heat setting.

Using the Timer

Count Down Timer
Use the Count Down Timer to set how long the cooking zone operates for one cooking ses-
sion.
Set the Count Down Timer after the selection of the cooking zone.
You can set the heat setting before or after you set the timer.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14
( comes on in the display).
/ . The indicator comes on. For
comes on in the dis-
A