Turning The Power On / Off - Shimano Steps E6000 Gebrauchsanweisung

„ Turning the power ON / OFF
Automatic power off function
If the bicycle has not moved for over 10 minutes, the power will automatically turn off.
< SC-E6010 >
Turning the power ON and OFF via the cycle computer
• Hold down the power button on the cycle computer for
2 seconds.
If internal battery of cycle computer isn't charged sufficiently,
the power will not turn on. The internal battery will be charged
if put on the bike after turning on.
< BT-E6000/BT-E6001/BT-E6010/BT-E8010/BT-E8020 >
Turning the power ON and OFF via the battery
Press the power button on the battery. The LED lamps will
light up indicating remaining battery capacity.
CAUTION
• When turning on the power, check that the battery is firmly
attached to the holder.
• Power cannot be turned on while charging.
• Do not place your foot on the pedals when turning on. A
system error may result.
BT-E8010/BT-E8020 can be forced to power off by holding down
the power button for 6 seconds.
NOTE
Power button
<BT-E6000/BT-E6001>
Power button
<BT-E6010>
<BT-E8010>
Power button
<BT-E8020>
24
Power button
Power button