Method Of Use; Introduction; Charging The Battery - Shimano Steps E6000 Gebrauchsanweisung

Method of use

„ INTRODUCTION
You cannot use the battery immediately after shipment.
The battery can be used after charging it with the designated charger.
Be sure to charge it before use. The battery can be used when the LED on it lights up.
The use of a genuine Shimano battery is recommended. If using a battery from another manufacturer, make sure to carefully
read the instruction manual for the battery before use.
„ Charging the battery
DANGER
• Use the battery and charger combination specified by the company for charging and follow the charging conditions specified by the
company. Not doing so may cause overheating, bursting, or ignition of the battery.
• When removing the battery charger power plug from the outlet or the charging
plug from the battery, do not pull it out by the cord.
• When charging the battery while it is mounted on the bicycle, be careful not to
trip over the charger cord or get anything caught on it. This may lead to injury or
cause the bicycle to fall over, damaging the components.
• If the bicycle is stored for an extended period of time immediately after purchase,
you will need to charge the battery before using the bicycle. Once the battery is
charged, it starts to deteriorate.
• Connect to E-TUBE PROJECT and click [Connection check] to confirm whether the
battery in use is a genuine Shimano battery or another brand.
CAUTION
10