Operation; Inserting/Replacing The Batteries - Omnitronic BHD-02 Waist band amplifier Bedienungsanleitung

5. OPERATION

1. Open the battery cover and insert 6 mignon-batteries (type AA) or rechargeable batteries.
2. Attach the amplifier via the clip on the rear side on the belt.
3. Plug in the ¼" jack into the MIC IN-socket and put on the headset.
4. Turn the POWER/VOLUME-Control clockwise to turn on the device.
5. Adjust the tone via the TONE-Control.
6. You can connect further portable audio devices such as radios and CD/MP3 players via the AUDIO
IN-Socket.
7. If the POWER-Indicator turns red, change batteries or recharge rechargeable batteries.

5.1 Inserting/Replacing the batteries

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Caution!
11/12 11038882_V_1_0.DOC