5-3. Basic Key Operations
The counter unit is basically operated with keys in the following sequence:
Axis key, data input, and Operation key.
Following is an example of the key operations on X-axes.
Operate the Y- and Z-axes in the same way.
Start of operation
: Turn on the power switch.
Reset (zero display)
:
Preset
:
Cancel
:
5-4. Correcting Erroneous Operations
1) When you have pressed the wrong axis selector key:
2) When you have pressed the wrong number key:
RESET
RESET
Number keys (data input)
X
X
• To select the correct axis, press the correct axis selector key.
• To clear the axis selection mode, press the cancel key
Press the cancel key
and axis selector key before entering the correct numerals. If you
have pressed the
key by mistake, press the axis selector key before entering the correct
P
numerals.
P
.
17