Operation; Cautions On Operation; Initial Settings - Sony LG10 Bedienungsanleitung

5. Operation

Cautions on Operation

1) When a malfunction occurs, characters as shown in "7. Alarm Display" on page 24 are
2) If two or more operation keys are pressed simultaneously, a malfunction may be caused.
3) Make sure that the least significant digit of an entered value agrees with the selected

5-1. Initial Settings

Before staring the operation, make the following initial settings:
• Skip unnecessary initial settings by pressing an Axis selector key, and proceed to the next setting.
• After all the initial settings are completed, press the
• By pressing the
• The initial settings, once made, are stored even if the power is turned off. Therefore the initial
• The displays corresponding to the axis selector key when performing initial setting are as follows:
displayed in place of numerals.When the alarm display appears, press the
relevant axis and repeat the operation.
resolution.
5-1-1. Setting the resolution and polarity
5-1-2. Setting the display resolution
5-1-3. Setting the linear campensation
5-1-4. Setting inch start or millimeter start
measurement mode.
key at any time during initial setting, the unit is switched to the measurement
RESET
mode. To return to the initial setting mode, turn off the power and repeat the above process.
settings are necessary only when the system is newly installed or when any setting revision is
required.
Connected scales
Connector 1 axis
Connector 2 axes
Connector 3 axes
RESET
Axis Axis Selector Key
X
X-axis
Y
Y-axis
Z
Z-axis
key for the
RESET
key. The unit is switched to the
Display
9