Handling Instructions - Sony LG10 Bedienungsanleitung

1-2. Handling Instructions

• Do not route the head connecting cable, power cord, etc, together with the machine power line
in one duct.
• Supply power from an AC lamp source.
• Connect the ground terminal to the machine with the supplied ground wire. Make sure the
machine is grounded.
Remove paint or rust completely before
connecting the ground wire.
• Place the counter unit more than 0.5 m (20") away from a high voltage source, large current
source, large power relay, etc.
• For installation of the counter unit, avoid a location exposed to chips, cutting oil, or machine oil.
If unavoidable, take adequate countermeasures.
• Do not put a vinyl cover directly over the counter unit or put it in a closed container.
• The ambient temperature should be in the range of 0 to 40°C (32 to 104°F). Avoid exposure to
direct sunlight, hot air currents, or heated air.
Switchboard
(Locate more than 0.5 m/20" away.)
Welder
• If the power supply voltage is lower than specified, the display may not be illuminated even with
the power switch turned on.
Be sure to use the power in the specified range.
• Note that if the power is interrupted momentarily or the voltage drops temporarily below the
normal operating range, an alarm may operate or a malfunction may occur.
• Be sure to use the counter unit inside.
Ground wire
Cutting oil
Machine oil
Ø
P
RESET
X
Ø
P
7
RESET
4
Y
P Ø
1
RESET
Z 0
ON
POWER
OFF
SIGNAL IN 1
SIGNAL IN 2
∼100V-230V
AC IN
SIGNAL IN 3
R
Do not route these together with the
machine power line in one duct.
Chips
8 9 P
5 6
2 3
inch mm
LG10
35VA
!
3