Dust Extraction; Speed Regulation - Westfalia 85 93 99 Bedienungsanleitung

Dust Extraction

This saw is a powerful tool which produces a large amount of dust. As the tool
has a fully enclosed blade, forced dust extraction is particularly efficient. An
industrial vacuum dust extractor or a vacuum cleaner for domestic use can be
connected to the dust extractor flange (6) of the tool, using the dust hose kit.

To attach the hose disconnect the tool from the mains supply. Press the
hose end onto the dust extractor flange (6). Ensure the safety cutting shoe
can still move smoothly. Press the stepped adapter onto the vacuum hose.
Tape can be used to seal up, if required.

Ensure that the vacuum cleaner is recommended for use with a power
tool. Generally most wet and dry vacuum cleaners for domestic use are
suitable.

Forced dust extraction is particularly recommended when many cuts are
carried out as far fewer stoppages are required for cleaning the tool and
surrounding area.

Forced dust extraction should always be used when cutting hazardous
materials such as hard woods, MDF or ceramics.
Forced dust extraction is recommended when it is desirable to keep the
working area clean. If the material being cut is slightly damp, it is essential to
use forced dust extraction.

Speed Regulation

With the buttons (A) and (B) the speed of the saw blades can be set. The set
speed is shown in the display. During operation the blocks in the right part of
the display indicate the drop of speed under load. If the machine is overloaded
the LED of the overload protection flashes or lights up. In this case reduce the
advance rate and observe points 9 and 10 of the chapter "Cutting" and the
chapter "Overload Protection".
Operation
16