JVC SX-XDS33 Bedienungsanleitung Seite 5

4
Connect the speaker cord to the speaker
terminal of the leg
• Use the 6-meter speaker cords for front speakers and
15-meter speaker cord for rear speakers.
• Each speaker cord has its name tag attached to one end.
Attach the end without the name tag to the speaker
terminal.
Tag
1)
Insert the speaker cord inside the stand as illustrated
below.
• Pull the speaker cord out of the center of the stand by
about 50 cm.
2)
Insert the tips of the speaker cord into the leg and pull
them out as illustrated below.
To the speaker
terminal of the leg
The cord with the
black stripe is on this
side, facing up.
Stand
Leg
3)
Insert the speaker cord into the speaker terminal
inside the leg.
1 Press and hold the clamp.
2 Insert the exposed core of the speaker cord fully
into the terminal.
• Connect the cord with the black stripe to the ·
terminal.
3 Release your finger.
1
Leg
5
Attach the terminal cover to the leg.
Push cords fully inside the leg. Then fix the terminal cover
using the screw you removed in step 1 .
grooves
– 5 –
2 3
The cord with
the black stripe.
Terminal
cover
claws
To be continued on the next page
Screw