Cleaning And Maintenance - MPVTruma MicroDrop Pro Bedienungsanleitung

12. Inhale the aerosol solution using the
prescribed accessory.
13. When the treatment has been com-
pleted, switch the unit off by setting
the switch position "O" and discon-
nect the plug from the wall socket.
14. Wash the nebulizer and accessories
as described in the "CLEANING AND
DISINFECTION OF THE ACCESSO-
RIES" section.
15. Put the nebulizer, accessories and
power cord inside the carrying case
(pic. A / 15).

Cleaning and Maintenance

Cleaning of the main unit
At home:
Use a clean dry cloth and mild detergents
for cleaning the unit.
Dealer:
After cleaning the device can be comple-
mented for use with a new patient.
To do so, the following steps must be
performed:
– wipe disinfection (with common
disinfectants)
– add a new nebulizer set (e.g. the
practical year set)
– pressure control of the compressor
The device is now ready for use by a new
patient.
During cleaning operations, make
sure the internal parts of the unit
are not in contact with liquids and the
power cord is not connected.
Cleaning and disinfection
of the accessories
See nebulizer manual for
detailed information.
After each treatment:
The nebulizer, the mouth piece and the
nose piece must be sterilized by boiling in
water (for max. 10 minutes) or in auto-
clave (max. 121°C). We suggest you disin-
fect the mask by using cold disinfecting
liquids (solutions with hypochlorite).
Dry the nebulizer using a clean cloth; after
connect it to the air outlet (pic. A / 4),
switch the device on and let it work freely
for 5 -10 minutes.
Do not boil nor autoclave the
air tube and the masks.
Following carefully the cleaning and
disinfecting instructions is very impor-
tant for the product performance and
for a successful therapy.
English
23