MPVTruma MicroDrop Pro Bedienungsanleitung Seite 22

Device Safety Systems
Thermal Protector
The inhalation device is provided with a
temperature protection device which is
released when the device is overheating
switching the unit off.
Operating time:
90 min. ON, 15 min. OFF
Instruction for Use
Remove the compressor from
carrying case before use.
Check the unit before each use, in order
to check for possible function anomalies
and / or damages due to transport and / or
storage.
When inhaling, sit upright and relaxed at a
table and not in armchair as otherwise
you will constrict your respiratory passages
and impair the effect of inhalation.
1. As soon as you have unpacked the device,
check it for visible damages or defects.
In particular, check for cracks in the plastic
housing, which could expose electrical
components.
2. Check for accessories integrity.
3. efore using the device, proceed with
the cleaning operations as described in
the "CLEANING AND DISINFECTION"
section.
22
4. Open the nebulizer (pic. A / 9) by
turning the top in an anticlockwise
direction (pic. D). On the top an arrow,
together with "CLOSE" sign, suggest
how to close the nebulizer.
5. Make sure the water conduction cone
is properly fitted onto the air conduction
cone inside the nebulizer (pic. E).
6. Put the prescribed medication dose into
the nebulizer (pic. F). The graduated
scale can be useful to control the cor-
rect medication quantity.
7. Close the nebulizer by turning the two
parts in a clockwise direction, paying
attention that they are thoroughly
sealed.
8. Connect one end of the air tube to the
nebulizer (pic. G) and the other end to
the air outlet on the device (pic. A / 4).
9. Use the Pro nebulizer with inhalation
valve only with mouthpiece having
exhalation valve. When using the
masks or the nosepiece, it is not
necessary to keep inhalation valve:
remove it (pic. B / 16) and connect
the nosepiece or the masks directly
onto the nebulizer (pic. I).
10. Plug the device to the wall socket,
making sure that the electrical rating
shown on the rating plate on the bot-
tom of the unit corresponds to your
main voltage.
11. To start the treatment, switch the
device on by pressing the switch
(pic. A / 2) in the front of the device
onto the "I" position.